Technical Library | 2018-10-03 20:41:44.0
Voids in solder joints plague many electronics manufacturers. Do you have voids in your life? We have good news for you, there are many excellent ways to "Fill the Void." This paper is a continuation of previous work on voiding in which the following variables were studied: water soluble lead-free solder pastes, a variety of stencil designs, and reflow profiles. Quad Flat No-Lead (QFN) component thermal pads were used as the test vehicle. The voiding results were summarized and recommendations were made for reduction of voiding.
SMTnet Express, October 3, 2018, Subscribers: 31,373, Companies: 11,056, Users: 25,258 Fill the Void II: An Investigation into Methods of Reducing Voiding Tony Lentz - FCT Assembly , Patty Chonis, JB Byers - A-Tek Systems Voids in solder joints
SMT Express, Volume 2, Issue No. 3 - from SMTnet.com Volume 2, Issue No. 3 Thursday, March 16, 2000 Featured Article Return to Front Page Curtailing Voids in Fine Pitch Ball Grid Array Solder Joints by Gary Morrison and Kevin Lyne
Heller 公司 | http://hellerindustries.com.cn/Vacuum-Void-Reduction-Reflow.pdf
], which is the major wear-out failure mode and major source of failure for surface mount (SMT) components in electronic assemblies [8]. A specific type of voiding called planar microvoiding has been shown to lower reliability either by effectively reducing the attachment area or by weakening the solder in regions of the solder joint
Surface Mount Technology Association (SMTA) | https://www.smta.org/knowledge/journal.cfm
, Gerald Kreindl, Markus Abstract 24-1 Pb-free Alloy Silver Content and Thermal Fatigue Reliability of a Large Plastic Ball Grid Array (PBGA) Package Richard Coyle, Heather McCormick, John Osenbach, P Abstract 2010 23-4 An Investigation Into The Development
.gif)
